JATONTEC Outdoor CPE
In order to get the best signal from eNB,please follow the under step to install and debug 4G CPE.
1.Preparation before installation
a) Please consult to Operator about the position of eNB.The CPE need to install close to the eNB, and also please ask for the horizontal angel of the transmit antenna and relevant information of eNB;
b) Please prepare handheld portable GPS and compass.
c) Please input the operator’s SIM card to CPE before installation.
2.Hardware’s connection and installation

b) Please refer to the following picture to fix the CPE on the correct position. Don’t totally deadlock the hoop if need to do some adjustment.

3.Adjustment for the direction of CPE

b) After power to the CPE for 2 minutes, It can search the signal and connect to the network of operator. By the lights on bottom(more RF lights on ,the signal stronger),adjust the CPE’s direction angel flatly(each horizontal angel by 25° as one point, each point, observe for 2 minutes), adjust the horizontal position until getting the best signal.


d) Keeping the CPE vertical, observe the current data of CPE, at the same time, adjust the CPE’s antenna around slightly. the ideal condition is antenna 0 and antenna 1’s RSRP values gap not exceeding 8db and the CINR value should stay above 5db.
e) After checking the CPE’s signal receipt is on best status, please fasten the hoop to make sure that any outside force will not change the height and direction of the CPE.
4.Network interference factor
If after the above adjustment, the CPE can't get the best and high quality of connection with eNB, please contact with the operator network department to make sure no interference around the installation place. please troubleshoot with the engineer from operator.